Я знаю здесь похожие вопросы, но мои настройки отличаются. В моей настройке подключения есть 3 перехода, и последнее подключение осуществляется через Kerberos.
Сегодня IS SH к первому компьютеру через подключение CyberArk с помощью такой команды: ssh username@hopname@172.2.2.2@172.1.1.1
This переместите меня в первую командную строку, через которую я подключаюсь к другому компьютеру с помощью sh, например: ssh 172.3.3.3
На этом компьютере я не могу войти в hive REPL с помощью команды 'hive'. Я набираю «beeline», который загружает улей REPL передо мной.
Это настройка для S SH Tunnel:
When I 'test tunnel configuration' this it appears to be successful:
Lastly I need to enter the main JDBC connection URL in the main page:
When I normally connect through beeline I can see that my connection is in this format:
jdbc:hive2://172.4.5.6:2400,172.5.6.7:2400,172.6.7.8:2400,172.7.8.9:2400,172.8.9.9:2400/;serviceDiscoveryMode=zooKeeper;zooKeeperNamespace=hiveserver2;sasl.qop=auth-conf;auth=KERBEROS;principal=hive/hadoop.hadoop.com@HADOOP.COM
Therefore this is the string I put into the JDBC URL.
When I try to connect through this setup the progress bar goes across a third of the way and pauses for 30 seconds and then I receive this message:
ошибка подключения dbeaver
Я не уверен, где находятся журналы ошибок для получения более подробной информации, но, просмотрев файлы dbeaver, я не нашел их.